Description
Width Adjustment
The width of the Adjust Cycling Shoe is controlled by a special wing on the side that flexes in or out to match the width of your foot.This special wing is locked in place by a dial. no matter you have wide or narrow feet, the shoe can adjust outward or inward to match.(Special wing is made from soft plastic and not flimsy so it keeps your foot from sliding around.)
Toe Adjustment
The toe length of the Adjust Cycling Shoe is controlled by a wing on the front of the shoe. The toe wing is pulled back by default but comfortably flexes out if you have long toes. This wing is very supportive yet flexible, its both comfortable and holds your foot well and you don’t lose any power. To tighten the toe wing inward, you will need to run the cable through the toe wing hook as shown below.
Re-Lace
You can customize the fit of the Adjust cycling shoe a bit further by re-lacing the cables to fit slightly differently.
This example shows how the cable are undone in the mid section to open the area up for wide girth feet. But the shoe is still held tight at the top and width area.
This example shows how to relace the cable to pull the toe height higher (for people with taller toes)
Heat Moldable Heel
The tips of the Adjust shoe are heat moldable with a hair dryer.
If you feel their is too much heel slip, or want a tighter fit, hold a hair dryer 10cm away from the heel for 2 minutes. The heel will soften, then you can squeeze it tighter. But be careful not to burn your hands because the shoe can get hot.
Reflective Side / Rear
The side and rear of the Adjust Cycling shoe is highly reflective for safety.
The Sole
Nylon Road
Dials
We use very durable and easy to replace MOZ dials.